AIR INTAKE CLEANING
CLEANING BUTTERFLIES, AIR INTAKE DUCT, TURBO AND EGR VALVE
A.I.C. AIR INTAKE CLEANING 400ml
For 2 and 4 strokes engines.
Turbo cleaning and intercooling by air intake
DISSOLVES GOMMES AND VARNISHES, PROTECTS AND RESTORES THE EFFECTIVENESS OF ELECTROMAGMETIC SENSORS
Instructions for use: A.I.C "Air Intake Cleaning":
- the engine must be hot
- insert the small A.I.C tube into the boa (hose between the air filter and the engine air inlet
- put back the boa necklace
- run the engine at about 1500 rpm (gasoline engine)
- at idle for diesel engines inject very small impulses the A.I.C (Diesel engines are racing, gasoline engines suffocate), so please go by very small impulses on the aerosol
- treatment may take 10 to 15 minutes.
AIC TREATMENT ALSO UPHOLDS ENGINE SEALING
Main Functions and Utility: The A.I.C is a multifunctional cleaner that acts on all parts and components of the intake air of the engine. It improves the operation of the engine and significantly reduce its pollution.
The Méca-Run A.I.C
Dissolves and removes all greasy deposits, gums and varnishes on the pieces.
Cleans parts of single-point and multipoint injection systems, throttle bodies, tubing, idle air valves ...
Cleans the carburetor or injection pump from the inside and the outside
Leaves anticorrosive lubricating film after cleaning.
Allows adjustment of the CO and HC values in the exhaust gases according to the manufacturer's standards.
Safe for catalytic converter engines and plastic and rubber seals
A single reference for all types of gasoline or diesel engines, with or without lead, carburetor or injection, with or without turbo.
Diesel engines of all types:
The procedure is exactly the same with gasoline injections.
Warning ! In diesel spray A.I.C is to increase the amount of fuel the engine will accelerate.
It will require a certain fingering to avoid everything on diet.
Be very careful with the turbos (start with a fraction of a second).
If the engine accelerates too much, immediately cut off the aerosol flow.
Get the job done by a professional if you do not have experience.
The MECA-RUN A.I.C is very effective to clean the filters of Direct Admission Kits: spray MECA-RUN A.I.C (filters and ducts) then dry with compressed air.
The result of cleaning performed only with A.I.C can be demonstrated with the gas analyzer or the opacimeter.
Note: A.I.C contains flammable substances, do not spray on hot surfaces such as turbochargers and exhaust pipes!
Use also on mowers, tillers, motorcycle 2 and 4 times etc ...